With the additional functions for room and ceiling planning, a partially automated generation of rooms, walls and ceilings takes place on the basis of a 3D floor plan.
Category: 3D modeling
This solution offers extensive additional functions for the analysis and optimization of constructions, 3D parts and 3D part structures that have been created in HiCAD or imported via 3D interfaces.
With the automated simplification functions and the extensions for the definition and administration of simplified substitute references, the preparation for the data export or for the use of complex machines in the layout construction can be significantly simplified, especially in the case of large constructions.
Also for the “BIM / IFC interface”, which is widespread in construction, the simplification functions can be used to automatically generate simplified models for LOD100-LOD300 from an exact LOD400 model.
Functions such as “internal reference of identical parts” also allow the amount of data to be significantly reduced, especially for the STEP- and IFC-export.
An excerpt of the available optimization functions is shown in the picture on the right.
This design variant provides extensive parameters for flexible 3D modeling of chains. Chain standards can be selected using the HiCAD company standard catalogs and can also be expanded individually at any time.
Chain courses can be individually defined using free points + radius, circular arcs or free sketch courses. If the reference elements are changed, the chain course optionally adapts to the changed geometry.
With the optimization of the chain length for minimal overlapping of the start / end link, a comprehensive solution for the creation of chains results.